LABOMAR TEKNOLOJİK ÇÖZÜMLER

Tel : 0216 417 70 01 / Fax : 0216 417 33 50

www.labomar.net   /  webinfo@labomar.net  

GENERAL PURPOSE SILICONE FLUIDS
Brookfield Silicone Viscosity Standards provide a convenient, reliable means of checking the calibration of most Brookfield Viscometers/Rheometers. These fluids, calibrated at 25^oC (77^oF), are available in 11 different viscosity ranges.

Brookfield Part #	Nominal Viscosity cP (mPa·s)	Specific Gravity
5 cps 10 cps 50 cps 100 cps 500 cps 1000 cps 5000 cps 12500 cps 30000 cps 60000 cps 100000 cps	5 10 50 100 500 1000 5000 12500 30000 60000 100000	0.920 0.940 0.960 0.968 0.972 0.972 0.972 0.973 0.973 0.973 1.000

HIGH TEMPERATURE SILICONE FLUIDS
These fluids are recommended for use with the Brookfield Thermosel Accessory.

Brookfield Part #	Nominal Viscosity cP (mPa·s)	Temperature
		oC	oF
HT 30000	30,000	25.0	77
	9,000	93.3	200
	4,500	149.0	300
HT 60000	60,000	25.0	77
	18,000	93.3	200
	9,000	149.0	300
HT100000	100,000	25.0	77
	30,000	93.3	200
	15,000	149.0	300

KU-2 OIL FLUIDS
These oils are recommended for use with Brookfield KU-2 Viscometers

Brookfield Part#	Nominal Viscosity Krebs Units	Temp oC
KU64 KU79 KU84 KU95 KU106	64 79 84 95 106	25.0 25.0 25.0 25.0 25.0

SPECIAL PURPOSE OIL FLUIDS
These oils are recommended for use with Cone/Plate and coaxial cylindar geometry at viscosities above 5,000 cP (mPa·s) or measurements at shear rates above 500 sec^-1

Brookfield Part #	Nominal Viscosity	Temp o
B31 B210 B750 B1400 B2000 B11000 B20000 B80000 B200000 B420000	31 210 750 1,400 2,000 11,000 20,000 80,000 200,000 420,000	25.0 25.0 25.0 25.0 25.0 25.0 25.0 25.0 25.0 25.0

CAP OIL FLUIDS
For calibrating CAP Series cones, each spindle has its own fluid.
E.g. CAP1L fluid is for use with CAP 01 spindle on a low temperature CAP viscometer.

Note:
(1) The Part # designates which fluid to choose for each cone spindle, i.e. CAP3L - use with cone/spindle #3 (low temperature CAP).